Settings On LIPI PB2 Printer (Passbook)

19 Jul 2013

Social:

If you want to know more about printer settings and configuration stuff then you should see this stuff.

For banking printer (passbook printer and other) configuration click here

For banking printer configuration (passbook printer and other) click here

If you want to know about LIPI PB2 Passbook printer then click here.

If you want to know about core banking system that how bank system will working then click here to know

 

To View The Existing Settings On The Printer

1.To see the existing settings on the printer, switch OFF the printer.

2.HOLD station 2 for 5 seconds and simultaneously switch ON the printer.

3.Insert a paper to print and see the EXISTING settings on the printer. ITS SHOWS ALL TYPES OF IN-BUILT SETTINGS THAT IS ALREADY THERE IN THE PRINTER.

4.The exact configuration for PASSBOOK is BASIC CONFIG and IBM CONFIG.

To Change The Settings On The Printer

1.To change the already existing printer settings, SWITCH OFF THE PRINTER, AND then HOLD (station 1 + station 2 simultaneously) for 5 seconds and then simultaneously switch ON the printer.

2.Insert the paper and it’s automatically sucked in to the printer.

3.The printer paper shows station 1 to go to next MENU and station 2 to go to SUBMENUS with in MENUS.

4.and it shows local to EXIT.

5.The following is the exact CONFIGURATIONS

BASIC AND IBM CONFIG.

BASIC CONFIG.
EMULATION > CITIC -IBM
CX EMULATION > EPSON
EMUL. TYPE > TEMP.
DRAFT SPEED > NORMAL
LQ TYPE > NLQ1
BUZZER > YES
INTERFACE > AUTO
BAUD RATE > 9600
BIT/CHAR > 8
PARITY > NONE
STOP BIT > 1
DSR >NO
DCD > NO
PAP.EDGE DETECT > NO
SPECIAL FOEMS > NO
CMPL PIN > NO

After this BASIC CONFIG, the IBM CONFIG is changed as below.

IBM CONFIG
EMULATION > IBM PP II
PASSBOOK > YES
BINDING > VERTICAL
ASCII/KANJI ***** > ASCII
CHAR. SET > PC
PC CHAR SET > 437 (INT)
PC TABLE > TABLE 2
CHAR DEFINITION > LQ
CPI > 17.1
LF+CR > NO
CR+LF > NO
SLASH ZERO > NO
LINE WIDTH > 8 IN
FORM LENGTH > 11 IN
LIKE IBM-PP BOF > YES
LIKE IBM-PP TOF > YES
SELECT PNS > NO

6. Then after settings are made on the printer, it will ask Save Parameters, then press station 1 to YES or CONFIRM… If parameters are not properly set, Press station 2 to Don't Confirm.

7. Switch off and switch on the printer again.

8. After that printer settings successfully completed.

Note:All content is copyrighted to http://sm-information.blogspot.com and may not be reproduced on other websites.

If you have any question regarding this websites or any other post related you can Email us.

Post Category : How To Guide , Printer Guides